EMO Hannover 2019,
16 - 21 September
Clamp difficult or easily deformable workpiecesIn daily use you are optimally equipped with the TOPlus or SPANNTOP chucks. However, there are always components that are difficult to clamp due to the contour, or that will be deformed through radial clamping. So what is required is an axial chuck, which in addition can also be set-up very fast. Clamp axially on a neodymium magnetThe answer: HAINBUCH magnet module. With the magnet module you can clamp components axially on a neodymium magnet. The HAINBUCH magnet module is set-up in only 30 seconds. Your basic clamping device is already mounted. You exchange the clamping head that is included in the scope of delivery. When clamping, the magnetic clamping device is pulled onto the flat contact area of your basic clamping device. Planar change-over accuracy of 2 μmIf, after initial installation, the magnet module is planed flat and the install position is marked, a planar change-over accuracy of 2 μm can be achieved. The workpiece itself is clamped by hand on the magnet.Adaptation to magnetic clamping• End face axial clamping via neodymium magnet• High face-run change-over accuracy• High holding force of 140 N/cm²• Assembly in 30 seconds without aligning• low-maintenance, resistant to contamination
Reliable and long life
SPANNTOP nova – this development represents more than 30 years of SPANNTOP experience. It exploits all the advantages of the latest machine ...
Easy manual actuation
The TOROK manual chuck is primarily used in tool prototyping on machines without a clamping cylinder. For example, thanks to its easy manual ...
Concentric and eccentric complete machining
Concentric and eccentric complete machining in a single clamping set-up? That’s right! With our compact chuck you can ...
Flexibility thanks the modular system
I.D., O.D. or jaw clamping – it's easy with the B-Top3 modular system. Everything fits together. With the MANDO Adapt segmented ...
Flexible for small lot sizes
Fast jaw change with quick change design and high repeatability – that is what makes the B-Top jaw chuck product line so flexible. ...
The »mini« series really shines with a mass reduced by as much as 30 %, and a chuck diameter that is reduced by 1/3. This means reduced energy consumption ...
MANOK plus, the extended variant of our manual MANOK stationary chuck offers you an integrated forced release function. With the integrated ...
Up to 25 % more clamping force and higher output – with the same clamping cylinder that is used to actuate our SPANNTOP chucks. The pyramid ...
Extremely high clamping force
Often complete machining fails for lack of an effective I.D. clamping device. In many cases the jaw chuck is a makeshift solution. ...
Quality that inspires
It isn’t just the price-performance ratio of MANOK that is impressive. With its incredible holding power, precision and rigidity, MANOK has ...
Whether lathe or machining center
Complete machining made easy: You cannot only use our MANDO and MAXXOS segmented mandrels on the lathe, you can also use them ...
Always use the right clamping device
With the jaw module in our HAINBUCH modular system, you are able to always use the right clamping device. More than 80 % of ...
Made for the gear-cutting sector
Clamping solutions for the gear-cutting sector are individual and have very special requirements. Consequently, it is not easy ...