EMO Hannover 2019,
16 - 21 September
Lower massThe »mini« series really shines with a mass reduced by as much as 30 %, and a chuck diameter that is reduced by 1/3. This means reduced energy consumption and better tool accessibility. Naturally, add on clamping elements can also be used with the TOPlus mini chuck. To maintain the minimal interference contour, the TOPlus mini chuck has its own adaptation devices with a smaller bolt hole circle. Reduced interference contourThanks to the reduced interference contour, it is easier to choose the tool that you need. Now it can also be shorter and more stable – on the main and sub spindles. Particularly in the case of limited installation space and in series operation, the TOPlus mini chuck is ideal: Lower energy consumption, dynamic spindle acceleration, and shorter cycle times reduce the costs per workpiece.The most important to know• Quick change-over to I.D. clamping or 3-jaw clamping [modular system]• 25 % higher holding power than SPANNTOP• Significantly reduced interference contour• Improved tool accessibility• Ideal for limited installation space• Lower mass• Minimal inertia loss compared to 3-jaw chucks Advantages• Workpiece clamping without axial movement of the clamping head• Clamps workpieces with a short collar or shoulder• Suitable for pick-off without pull-back effect• Prepared for inside and front end-stop• Converts to a fully functional »bar chuck« when the end-stop plate is removed
Clamp difficult or easily deformable workpieces
In daily use you are optimally equipped with the TOPlus or SPANNTOP chucks. However, there are always components ...
Reliable and long life
SPANNTOP nova – this development represents more than 30 years of SPANNTOP experience. It exploits all the advantages of the latest machine ...
Easy manual actuation
The TOROK manual chuck is primarily used in tool prototyping on machines without a clamping cylinder. For example, thanks to its easy manual ...
Concentric and eccentric complete machining
Concentric and eccentric complete machining in a single clamping set-up? That’s right! With our compact chuck you can ...
Flexibility thanks the modular system
I.D., O.D. or jaw clamping – it's easy with the B-Top3 modular system. Everything fits together. With the MANDO Adapt segmented ...
Flexible for small lot sizes
Fast jaw change with quick change design and high repeatability – that is what makes the B-Top jaw chuck product line so flexible. ...
The »mini« series really shines with a mass reduced by as much as 30 %, and a chuck diameter that is reduced by 1/3. This means reduced energy consumption ...
MANOK plus, the extended variant of our manual MANOK stationary chuck offers you an integrated forced release function. With the integrated ...
Up to 25 % more clamping force and higher output – with the same clamping cylinder that is used to actuate our SPANNTOP chucks. The pyramid ...
Extremely high clamping force
Often complete machining fails for lack of an effective I.D. clamping device. In many cases the jaw chuck is a makeshift solution. ...
Quality that inspires
It isn’t just the price-performance ratio of MANOK that is impressive. With its incredible holding power, precision and rigidity, MANOK has ...
Whether lathe or machining center
Complete machining made easy: You cannot only use our MANDO and MAXXOS segmented mandrels on the lathe, you can also use them ...
Always use the right clamping device
With the jaw module in our HAINBUCH modular system, you are able to always use the right clamping device. More than 80 % of ...
Made for the gear-cutting sector
Clamping solutions for the gear-cutting sector are individual and have very special requirements. Consequently, it is not easy ...