EMO Hannover 2019, 16 - 21 September

    EMO Hannover 2019, 16 - 21 September
    Homepage>Exhibitors & Products >Lathe chuck, hand operated - Magnet module

    Lathe chuck, hand operated - Magnet module

    Logo Lathe chuck, hand operated - Magnet module

    Product description

    Clamp difficult or easily deformable workpieces

    In daily use you are optimally equipped with the TOPlus or SPANNTOP chucks. However, there are always components that are difficult to clamp due to the contour, or that will be deformed through radial clamping. So what is required is an axial chuck, which in addition can also be set-up very fast.

    Clamp axially on a neodymium magnet

    The answer: HAINBUCH magnet module. With the magnet module you can clamp components axially on a neodymium magnet. The HAINBUCH magnet module is set-up in only 30 seconds. Your basic clamping device is already mounted. You exchange the clamping head that is included in the scope of delivery. When clamping, the magnetic clamping device is pulled onto the flat contact area of your basic clamping device.

    Planar change-over accuracy of 2 μm

    If, after initial installation, the magnet module is planed flat and the install position is marked, a planar change-over accuracy of 2 μm can be achieved. The workpiece itself is clamped by hand on the magnet.

    Adaptation to magnetic clamping

    • End face axial clamping via neodymium magnet
    • High face-run change-over accuracy
    • High holding force of 140 N/cm²
    • Assembly in 30 seconds without aligning
    • low-maintenance, resistant to contamination

    Product website

    Hall 3, Stand H20

    More products from HAINBUCH

    Show more

    Stored items


    Server communication error: Item could not be saved.