EMO Hannover 2019,
16 - 21 September
Incredibly versatileMANOK plus, the extended variant of our manual MANOK stationary chuck offers you an integrated forced release function. With the integrated forced release function you can not only use our adaptations on the lathe you can also use them stationary.Fast assemblyWithin just a few minutes you have mounted the MANDO Adapt mandrel or the jaw adapter. With the jaw adapter the doubled clamping range is available.Flexible standard equipmentHorizontal clamping surface and alignment fixation grooves are standard equipment, and so is the integrated end-stop.Key advantages• Quick change-over to I.D. clamping or 3-jaw clamping [modular system]• Also available in a CFRP lightweight design• Sensitive manual clamping is possible• Workpiece stabilization through axial draw force applied against the workpiece end-stop• Ideal for 5-sided machining
Clamp difficult or easily deformable workpieces
In daily use you are optimally equipped with the TOPlus or SPANNTOP chucks. However, there are always components ...
Reliable and long life
SPANNTOP nova – this development represents more than 30 years of SPANNTOP experience. It exploits all the advantages of the latest machine ...
Easy manual actuation
The TOROK manual chuck is primarily used in tool prototyping on machines without a clamping cylinder. For example, thanks to its easy manual ...
Concentric and eccentric complete machining
Concentric and eccentric complete machining in a single clamping set-up? That’s right! With our compact chuck you can ...
Flexibility thanks the modular system
I.D., O.D. or jaw clamping – it's easy with the B-Top3 modular system. Everything fits together. With the MANDO Adapt segmented ...
Flexible for small lot sizes
Fast jaw change with quick change design and high repeatability – that is what makes the B-Top jaw chuck product line so flexible. ...
The »mini« series really shines with a mass reduced by as much as 30 %, and a chuck diameter that is reduced by 1/3. This means reduced energy consumption ...
Up to 25 % more clamping force and higher output – with the same clamping cylinder that is used to actuate our SPANNTOP chucks. The pyramid ...
Extremely high clamping force
Often complete machining fails for lack of an effective I.D. clamping device. In many cases the jaw chuck is a makeshift solution. ...
Quality that inspires
It isn’t just the price-performance ratio of MANOK that is impressive. With its incredible holding power, precision and rigidity, MANOK has ...
Whether lathe or machining center
Complete machining made easy: You cannot only use our MANDO and MAXXOS segmented mandrels on the lathe, you can also use them ...
Always use the right clamping device
With the jaw module in our HAINBUCH modular system, you are able to always use the right clamping device. More than 80 % of ...
Made for the gear-cutting sector
Clamping solutions for the gear-cutting sector are individual and have very special requirements. Consequently, it is not easy ...