EMO Hannover 2019, 16 - 21 September

    EMO Hannover 2019, 16 - 21 September
    Homepage>Exhibitors & Products >HYPROSTATIK SCHÖNFELD
    Logo HYPROSTATIK SCHÖNFELD

    HYPROSTATIK SCHÖNFELD

    Logo HYPROSTATIK SCHÖNFELD
    Exhibition stand
    Hall 7, Stand A52
    Open Exhibition Grounds map

    Company Data

    Hyprostatik Schönfeld GmbH

    Felix-Hollenberg-Straße 3
    73035 Göppingen
    Germany
    Send E-mail
    Fax: +497161965959-10

    Contact(s)

    Ms. Maren Röding
    Journalist contact
    Send E-mail

    Exhibitor press release

    17.09.2017 [D]

    Hydrostatic rotary tables

    "Hyprostatik" rotary table systems are available with torque motor drive with angle measure system  for C-axis or B-axis use or for belt drive for rotation use. Rotary tables available for measure machines with very high precision angle measure system up to 1,6m and 40to load. With the use of the PM controller, several times stiffness is achieved compared to solutions using capillaries. This produces extraordinarily high stiffness with respect to radial, axial and moment loads. With the help of extensive... read more

    17.09.2017 [D]

    Hydrostatic centre spindles

    Design in different sizes available with rotary joint for clamping or unclamping by air or oil pressure. "Hyprostatik" centre spindles are available without drive, with belt drive or with torque motor drive. With the use of the PM controller, much higher stiffness is achieved compared to solutions using capillaries. This produces extraordinarily high stiffness with respect to radial, axial forces and tilt torque. By own hydrostatic bearing calculation software, an optimum in dimensioning is also achiev... read more

    11.06.2017 [D]

    New hydrostatic guide shoes

    Highest precision and best surface quality on work piece require hydrostatic linear guide in machine tool. With new developed guide shoes, standard elements can be used, which reduce effort for development and assembly much. Slide and guide are simpler to produce, because hydrostatic pockets, flow control and pressure sensors are in guide shoe.     Machine tools get in vibration by process forces, drive and vibration by unbalanced spindles. Hydrostatic guide damps vibration excellent and enable b... read more

    06.06.2017 [D]

    Tailstock with hydrostatic bearings

    At high weight or big bore of work, there is danger of damage of centers at sliding contact areas. There, most time rotating centers are used, which typically have runout is 2 to 5 µm, so runout is not good enough for most precision grinding shafts. Also rigidity of these rotating centers is low by the roller bearings inside.       Actual limitations by use of conventional tailstocks   At high precision finish grinding or hard turning, long shafts are fixed between centers with axial ... read more

    Stored items

    0

    Server communication error: Item could not be saved.