EMO Hannover 2019, 16 - 21 September

    EMO Hannover 2019, 16 - 21 September
    Homepage>News
    Trends Cutting Tools

    Tool-change and resetting times significantly reduced

    The tool-holding fixtures from Göltenbodt are 100-percent pre-settable outside the machine tool and can slash tool change and resetting times by up to 60 percent.

    01 Jul. 2017
    0157
    GWS tool holders can be preset to 100 percent outside the machine and are equipped with an internal coolant supply.

    Reputable OEMs and thousands of users worldwide reportedly place their confidence in the modular GWS system technology from Göltenbodt since it represents maximum cost-effectiveness and precision. The devices are hundred-percent pre-settable outside the machine tool in X, Z and Y and quick-changeable with a repeatability of better than 0.01 mm. The tooling systems are claimed to reduce tool change times and resetting times by a remarkable figure of up to 60 percent over conventional tool-holding systems. The holding systems are available for most of the multi-spindle machine tooling such as Tornos, Index, Schütte, Gildemeister, Mori-Say, and Wickman. All the tool holders are equipoped with a coolant-through feature for coolant pressures up to 35 bar.

    Contact: Nora Göltenbodt, Göltenbodt technology GmbH
    Tel. +49 7152 92818-27
    E-mail: info@goeltenbodt.de
    Website: www.goeltenbodt.de

    Picture to download

    More on the topic

    Precision tools

    spacer_bg